The spacer sample is outside its marked range

Your task: T3 drawing-revision hold

You are exploring Turner work in a fictional case. Prepare a two-feature comparison and a revision hold note. Distinguish the recorded readings from a fresh inspection. Develop one work sample as you investigate. Your writing stays on this page unless you download it.

Supplied fictional records

Fictional stepped shaft T3, drawing rev B: shoulder diameter 20–22 mm, end diameter 10–11 mm. Inspection sheet gives shoulder 23 mm and end 10.5 mm, but its heading says rev A. No real lathe or acceptance authority is involved.

TARGET RANGE
20 -------- 21 -------- 22        23
[----------------------]          ^ T3
                         <--- 1 mm --->
Classroom measurement comparison, not a machining instruction.

Prepare a two-feature comparison and a revision hold note. Distinguish the recorded readings from a fresh inspection.

One case, one work sample

1. Understand your role and task
2. Inspect the supplied records
3. Investigate the case

   Request both supplied checks before deciding. Each response becomes part of this same work sample.

4. Make or revise your decision

   Use the replies to choose the focus of your next draft. Keep the other open responsibilities in your note. You can revise this focus without losing your writing.

5. Complete your work sample

   Your records and investigation are already included. Prepare a two-feature comparison and a revision hold note. Distinguish the recorded readings from a fresh inspection. Add your own explanation or next question.

6. Compare and reflect

   Compare your work sample with one possible explanation. You can return to edit your work before finishing. Reflection is about what you noticed, not a score.